Issue |
SICOT-J
Volume 10, 2024
|
|
---|---|---|
Article Number | 48 | |
Number of page(s) | 7 | |
Section | Hip | |
DOI | https://doi.org/10.1051/sicotj/2024045 | |
Published online | 19 November 2024 |
Original Article
Total hip arthroplasty via the direct anterior approach using a conventional traction table and fluoroscopy: a safe and cost-effective technique
1
Department of Orthopaedic Surgery, Yokohama Tsurugamine Hospital, Kanagawa, Japan
2
Department of Orthopaedics, Faculty of Medicine, Juntendo University, Tokyo, Japan
3
Department of Medicine for Orthopaedics and Motor Organ, Juntendo University Graduate School of Medicine, Tokyo, Japan
* Corresponding author: seishii@juntendo.ac.jp
Received:
27
July
2024
Accepted:
11
October
2024
Introduction: Precise implant positioning during total hip arthroplasty (THA) is an important factor affecting dislocation rate and long-term implant survival. Although a special carbon fiber traction table for THA improves the accuracy of implant positioning, it is too expensive. We aimed to report the accuracy of cup positioning and complication rate in patients undergoing THA using a conventional noncarbon fiber traction table, which is generally used for osteosynthesis of femoral fractures. Methods: This retrospective study included 62 patients who received primary THA via the direct anterior approach using a conventional traction table with fluoroscopy between July 2022 and December 2023. Two observers recorded radiological outcomes using postoperative anteroposterior X-rays. The intraclass correlation coefficients of cup positioning angles were evaluated (inclination: 0.92, anteversion: 0.88 for intra-observer agreement; inclination: 0.91, anteversion: 0.84 for inter-observer agreement). Complications were defined as dislocation, periprosthetic fracture, ankle fracture, implant loosening, nerve injury, surgical site infection, deep vein thrombosis, and revision surgery for any reason. Results: Radiographic analysis showed an average cup inclination of 38.5° ± 4.3° (98.4% within Lewinnek’s safe zone). The average cup anteversion was 12.6° ± 4.6° (100% within Lewinnek’s safe zone). None of the patients experienced any complications. Discussion: A conventional traction table could be a feasible alternative to a carbon fiber traction table for performing THA via the direct anterior approach using fluoroscopy at general hospitals.
Key words: Direct anterior approach / Total hip arthroplasty / Fluoroscopy / Component positioning / Component safe zone
© The Authors, published by EDP Sciences, 2024
This is an Open Access article distributed under the terms of the Creative Commons Attribution License (https://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.